• Contact
  • Hotline : (021)4202447
  • SMS : 081210709777

Kontak Kami

Happy shopping, Biker!

Senin - Jumat 10:00 s/d 18:00, Sabtu 10:00 s/d 16:00, Minggu & Hari Besar Tutup
Harga di website dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu. Silahkan menghubungi Customer Service kami untuk mengetahui harga terbaru di showroom kami


Ditambahkan pada: 29 December 2016 / Kategori: , , ,
Best Seller

klik full size
Kode : 9009
Berat : 100 gram
Dilihat : 1.724 kali
Review : Belum ada review
Rp 170.000
Cara Pemesanan How to Order?
Pesan melalui SMS? Klik SMS
Bayar di tempat? Klik COD

Bagikan informasi tentang CANYON DANCER STRAP RING kepada teman atau kerabat Anda.


The Strap Ring is made in the USA of stainless steel. It allows the customer to attach tie-downs almost anywhere there is an 8mm or smaller bolt (smaller bolts obviously are not as strong).  The Strap Ring is break tested at 2000 pounds EACH which far exceeds all the tie down hooks or carabineers on the market. The original and main idea was to give the motorcyclist a place to attach tie downs to the triple clamp of a dirt bike but we have found a million other uses, for instance, in the bed of a truck or trailer, behind passenger peg bolts as a place to attach luggage straps on a street bike or anywhere you can put a bolt!  The eye is large enough to accept the large size 3/8 inch coated tie down hooks as well as 8mm carabineers and comes packaged in pairs.


Is that little ring really strong enough to hold my bike?

Absolutely! We have tested the Strap Ring to it’s breaking point and that is somewhere beyond 2200 lbs. EACH. It doesn’t bend at 2000 lbs. The ring distorts or bends at 2200 lbs. but still doesn’t break.

Will it rust? I noticed that it isn’t painted or coated with anything.

It is made of stainless steel.

Can it be used for other stuff?

Absolutely. My son is a building contractor and uses them to secure his ladders inside his equipment trailer. I use them as a place to attach bungee straps to the rear of my bike. They fit nicely under the muffler hanger bolts on my KTM.

Let us know if you have some clever uses for the Strap Ring.

Installation Instructions:

  • Simply remove a bolt where you want to have a tie down point and replace it again with the small side of the Strap Ring under the head.
  • The most common places are the upper or lower triple clamp pinch bolts.
  • Install the Strap Ring in a place that will not likely snag on riding gear or you!
  • Check for proper clearance of wires and control cables by turning forks from lock to lock.


  • The Strap Ring must lay flat under the bolt head and never in recessed or countersunk holes, unless the Strap Ring can lay flat inside the recess.
  • Position the ring toward the direction of pull, so pulling on the ring does not tend to loosen the bolt.
  • Install the Strap Ring in a place that will not likely snag on riding gear or you!
  • Check for proper clearance of wires and control cables by turning forks from lock to lock.
  • The bolt you place the Strap Ring under must still be long enough not to compromise it’s strength or it’s originally intended use.
  • Use a longer bolt of equal or greater strength if necessary!

Using Blue Loc-tite is always a good idea.

Belum ada review untuk CANYON DANCER STRAP RING

Silahkan tulis review Anda

Your email address will not be published. Required fields are marked *



Jalan Bungur Besar No. 153
(Belakang Stasiun Senen)
Bungur, Senen
Jakarta Pusat

Hotline (021)4202447
SMS/WA 081210709777
Email karin_motor@yahoo.com